[SR-Users] Issue with INVITE to NATed client

[SamyGo]

Hi,
Can you share the config file. Seems you've made changes to configuration
file. Using save("location") w/o any authentication above it will result in
anyone getting 200OK for a REGISTER.

Looking at the config will help point you to the right way.

Regards,
Sammy


On Fri, May 5, 2017 at 10:56 AM, Iskren Hadzhinedev <
iskren.hadzhinedev at ikiji.com> wrote:

> Hi list!
>
> I'm using kamailio 4.2 for load-balancing and failover via dispatcher, but
> I'm having some NAT related issues and I was hoping that someone might
> point me in the right direction.
> My setup is the following:
>
> PSTN - PBX - kamailio - NAT - client
>
> Calls from the NATed client to PSTN and/or PBX features (e.g. voicemail)
> work just fine.
> However, when a call comes from PSTN to the client, kamailio sends the
> INVITE to the client's RFC1918 IP and I can't figure out how to send it to
> the correct destination. I tried loading the registrar and usrloc modules
> and used save("location") during REGISTER and lookup("location") just
> before loose_route(), but the end result was that kamailio replied to
> REGISTERs with any username/password with a 200 OK and the endpoints never
> registered with the PBX.
> I can attach the config file if that will help.
>
> Thanks for all input in advance!
>
> Regards,
> Iskren
>
> _______________________________________________
> Kamailio (SER) - Users Mailing List
> sr-users at lists.kamailio.org
> https://lists.kamailio.org/cgi-bin/mailman/listinfo/sr-users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.kamailio.org/pipermail/sr-users/attachments/20170505/2ffaf6f6/attachment.html>