[SR-Users] Carrierroute failover domain not working

[JR Richardson]

On Thu, May 27, 2010 at 2:39 AM, marius zbihlei <marius.zbihlei at 1and1.ro> wrote:
>
>>
>> I think the database entries are setup ok, I used the example in the
>> module doc, but I can share that if needed.  Any guidance will be
>> appriciated.
>>
>> Thanks.
>>
>> JR
>>
>
> Hello JR
>
> Can you provide more info regarding the problem. Any special logging info in
> the debug log?
>
> You can increase the debug level to 3 (higher means more verbose) by using
> the command `kamctl fifo debug 3`

Debug loggin is set to 9.  The simulation is when a gateway is totally
off-line, so there is no response at all.  Here is a trace with a call
from sipp to kamailio, the call is sent to the first gateway in
carrier 1, domain 1.  The gateway is off-line, no response.

The pastebin has my kamailio.cfg, the kamailio debug trace and the
error received by sipp and the ngrep capture.

http://pastebin.com/VQziKYjE

>
> Also what reply do you get from A and B boxes? Failure_route is only
> executed if reply code is > 300 on all branches... I will check your other
> mail because this might be the problem.
>
> Also a trace of the call will help. ngrep is very usefull (ngrep -W byline
> -d any sip port 5060 does the trick in most cases)
>
> Hope I was not that redundant and the info helps.
>
> Cheers
> Marius
>

Thanks for having a look.

JR
-- 
JR Richardson
Engineering for the Masses