[Users] How to use script variables in switch-cases?

[Bogdan-Andrei Iancu]

hmmm...sounds like a trap :)

ok...it is like in C++ (disclamer - this is based on Jerome's sayings as 
I mostly parallel with C++ ) ;)

regards,
bogdan

Jerome Martin wrote:
> On Mon, 2007-05-14 at 19:34 +0300, Bogdan-Andrei Iancu wrote:
>> Hi Jerome,
>>
>> you can use strings also - no cast will be done. But the values must be 
>> constants.
>>     
> Yes, I knew that, this was just a teaser so you could state that 
> unlike C++ Openser can handle non-int in switch statements :-) 
> (Somehow mitigating the comparison with C for the const requirement ...)
>> regards,
>> bogdan
>>
>>
>> Jerome Martin wrote:
>> > On Mon, 2007-05-14 at 12:12 +0300, Bogdan-Andrei Iancu wrote:
>> >> Hi Peter,
>> >>
>> >> the "case" syntax does not accept any variables, but only constant 
>> >> values (like in C also :) )
>> >>     
>> >
>> > But is it limited to int or implicitly-castable-to-int values, like in 
>> > C++ ?
>> >
>> > Cheers,
>> > Jerome 
>>
>>     
>