[Serusers] cisco 7905G

[Marcello Lupo]

Hi,
It is probably because the Cisco 7905 put his Public address (that you 
config under NAT IP address) only in the via header field and not in the 
>From or the contact field. Now is some time that i do not use that phone and 
do not remember correctly. In any case the SER use the correct Public IP in 
the answer but try to contact the port 5060 that is the port that it put in 
the header that SER use to contact it.
If i don't remember wrong may be SER answer correctly to other clients 
because them do not specify the port to contact and SER use the one from 
which the request is coming. Instead the Cisco specify port 5060.
If you send me a SIP trace i can help you find it.
Bye,
Marcello

----- Original Message ----- 
From: "Alberto" <alberto.ipt at telefonica.net>
To: "Marcello Lupo" <lupo at itspecialist.it>; <serusers at lists.iptel.org>
Sent: Tuesday, September 27, 2005 12:32 PM
Subject: Re: [Serusers] cisco 7905G


> Thanks for your response.
>
> I don't use STUN servers, I use SER with Mediaproxy.
>
> My other sip clients works ok, and they are a stupid sip clients too.
> I don't understand it, why the SER respond to private port and not to 
> public port?
>
> Thanks.
>
> --
> Alberto
>
>
>
> ----- Original Message ----- 
> From: "Marcello Lupo" <lupo at itspecialist.it>
> To: "Alberto" <alberto.ipt at telefonica.net>; <serusers at lists.iptel.org>
> Sent: Tuesday, September 27, 2005 11:58 AM
> Subject: Re: [Serusers] cisco 7905G
>
>
>> Hi,
>> the problem is that Cisco 7905G do not support STUN servers so it is not 
>> able to know on which port the request is sent out after NAT. It is a 
>> stupid SIP phone, in my opinion, to be used as SIP phone behind nat. 
>> Eventually you need a router that make symmetric nat so the 5060 internal 
>> port will be translated as 5060 out port but you will need in any case to 
>> open ports for RTP and 5060 fr incoming calls.
>> Bye,
>> Marcello
>>
>> ----- Original Message ----- 
>> From: "Alberto" <alberto.ipt at telefonica.net>
>> To: <serusers at lists.iptel.org>
>> Sent: Tuesday, September 27, 2005 11:00 AM
>> Subject: [Serusers] cisco 7905G
>>
>>
>>> Hi,
>>> I have the next scheme:
>>>
>>>    7905G ------- NAT ------- Internet ------ SER+mediaproxy
>>>
>>> When the 7905G sends a INVITE the ser responds:
>>>   Status: 407 Proxy Authentication Required.
>>>
>>> This is right, but the destination port this packet not is right because 
>>> the ser sends the packet with
>>> destination port 5060  (private port) and not the (public port). If I 
>>> open this port all it is right, I do not
>>> want to open no port.
>>>
>>> This single problem happens to me with 7905G (no linksys, no X-Ten, 
>>> ...).
>>>
>>> I do not understand what it is happening.
>>>
>>> Thanks for your aid.
>>>
>>> --
>>> Alberto
>>> _______________________________________________
>>> Serusers mailing list
>>> serusers at lists.iptel.org
>>> http://lists.iptel.org/mailman/listinfo/serusers
>>>
>>
>
>