[Serusers] RADIUS/LDAP

[Felipe Louback]

> Should work OK..
but it does not...

> Run both radius and ldap in debug mode.
> Check what is being asked for and what is being searched for in ldap.
>
> Use:
> "radiusd -X"
> "slapd -d 384"
I did... ldap receives nothing related to User-Password, but Radius
still complains about the required User-Password... but there is no
User-Password on Ldap. I checked other bases, and they all use
userPassword... I cant figure out why is Radius looking for this...

Felipe


> Felipe Louback wrote:
> > I'm putting my SER to authenticate on a LDAP base using RADIUS. But
> > when I try to authenticate any client, I get the following error:
> >
> > auth: type "LDAP"
> >   Processing the authenticate section of radiusd.conf
> > modcall: entering group Auth-Type for request 0
> > rlm_ldap: - authenticate
> > rlm_ldap: Attribute "User-Password" is required for authentication.
> >   modcall[authenticate]: module "ldap" returns invalid for request 0
> >
> > Into my LDAP, the correct field is userPassword and not User-Password,
> > as RADIUS is looking for... I already set in radiusd.conf:
> > password_attribute = userPassword
> > But still the same error....
> >
> > Any clues?
> >
> > Felipe
>
> _______________________________________________
> Serusers mailing list
> serusers at lists.iptel.org
> http://lists.iptel.org/mailman/listinfo/serusers
>


--
Master Student - Electrical Engineering Department
Computer Engineering and Telecommunications Research Group
Universidade Federal de Minas Gerais - Brazil

"Humanly speaking it is impossible; but with God anything is possible!"
Jesus Christ in Matthews 19:26