[Serusers] Portal for forking call to preferredenddevice-sequential ringing

[Aisling O'Driscoll]

Ok, just to recap - cos Im getting a little bit confused ;)

I have two choices(?)

1. Somehow invoke sipsak to configure permanent addresses with a
particular q value.
2. Develop a FIFO method to change q value.

Am I correct in thinking directly modifying the usrloc table in the
database is out of the question because the changes cant be updated
except by SER itself in which case a reboot would required - Correct?
Also lcr module (load_contacts() etc) isnt suitable for per user
configurable sequential forking?

Have others tried to implement similar functionality or is it usually
a generic site wide sequential forking policy?

Many thanks for the opinions and help so far.
Aisling.

>
>---- Original Message ----
>From: jh at tutpro.com
>To: greger at teigre.com
>Subject: Re: [Serusers] Portal for forking call to
>preferredenddevice-sequential ringing
>Date: Tue, 21 Jun 2005 21:41:54 +0300
>
>>Greger V. Teigre writes:
>>
>> > :-D Yes, that is true. But I didn't know that you could change
>q-value in 
>> > FIFO?  
>>
>>if that is not possible, then you can always use sipsak to install
>>"permanent" registrations with a given q value.  sipsak has an
>>additional advantage over fifo in that you can apply permissions
>check
>>to sipsak registration, but not to fifo registration.
>>
>>-- juha
>>
>>-------------------Legal 
>Disclaimer---------------------------------------
>>
>>The above electronic mail transmission is confidential and intended
>only for the person to whom it is addressed. Its contents may be
>protected by legal and/or professional privilege. Should it be
>received by you in error please contact the sender at the above
>quoted email address. Any unauthorised form of reproduction of this
>message is strictly prohibited. The Institute does not guarantee the
>security of any information electronically transmitted and is not
>liable if the information contained in this communication is not a
>proper and complete record of the message as transmitted by the
>sender nor for any delay in its receipt.
>>
>>



-------------------Legal  Disclaimer---------------------------------------

The above electronic mail transmission is confidential and intended only for the person to whom it is addressed. Its contents may be protected by legal and/or professional privilege. Should it be received by you in error please contact the sender at the above quoted email address. Any unauthorised form of reproduction of this message is strictly prohibited. The Institute does not guarantee the security of any information electronically transmitted and is not liable if the information contained in this communication is not a proper and complete record of the message as transmitted by the sender nor for any delay in its receipt.