[Serusers] Problems using REFER method using SER and Cisco gateway

[Raffaele]

Hello richard,

the refer to contains <sip:205 at publicnatipaddress;method?INVITE> and
the router sends directly to public_nat_ip_adress. I want to avoid it
trying to send the SIP packet to my SIP server but the destination of
INVITE should be exactly the same specifiied in the refer to.

 From the message sent by Juha it seems at the moment this is not supported
by Cisco..

Bye,
Raffaele.


Richard wrote:

>>I have a dial peer configured in this way:
>>
>>dial-peer voice 5 voip
>>application session
>>destination-pattern 2[0,1,5].
>>session protocol sipv2
>>session target sip-server
>>
>>and when I debug on the router the dial-peer is correcly matched.
>>However the gateway doesn't send the INVITE to the sip server but
>>directy to the "nat_public_ipaddress
>>
>>    
>>
>
>What's the refer-to look like? If there is a match, then cisco uses the
>refer-to field uri. It doesn't replace the domain in seesion target.
>
>Richard
>
>
>  
>