Hi,

I have just downloaded the latest cvs sources of rel_2_0_0.
I compiled and installed it as usually:

make proper
make prefix=/homedir install

after this each time I start ser it breaks down
here my log from console:

Starting SER SIP Proxy: ser
$Listening on
             udp: 127.0.0.1 [127.0.0.1]:7060
             udp: 192.168.129.38 [192.168.129.38]:7060
             tcp: 127.0.0.1 [127.0.0.1]:7060
             tcp: 192.168.129.38 [192.168.129.38]:7060
Aliases:
             tcp: venom:7060
             tcp: venom.touk.pl:7060
             tcp: localhost:7060
             udp: venom:7060
             udp: venom.touk.pl:7060
             udp: localhost:7060
             *: sip.rd.touk.pl:*

WARNING: no fork mode and more than one listen address found (will use only the the first one)
0(11117) init_tcp: using epoll_lt as the io watch method (auto detected)
0(11117) Maxfwd module- initializing
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) WARNING: xl_mod_init: more IP 192.168.129.38 not used
0(11117) AVPops - initializing
0(11117) using 'none' subscription authorization for presence!
0(11117) TRACE: qsa_interface.c:55: PA: PA_CONTENT_TYPE: 0x2ba1844692e0
0(11117) INFO: xcap_mod.c:55: xcap module initialization
0(11117) TRACE: virtual_subscription.c:55: RLS: RLS_PRESENCE_INFO: 0x2ba1844692e0
0(11117) TRACE: virtual_subscription.c:63: RLS: RLS_RAW: 0x2ba184479598
0(11117) using 'none' rls-subscription authorization!
0(11117) TRACE: qsa_events.c:331: presence_b2b: b2b_CONTENT_TYPE: 0x2ba1844692e0
0(11117) WARNING: tls: mod_init: tls support is disabled (set enable_tls=1 in the config to enable it)
exec - initializing
ERROR: error -1 while trying to fix configuration

Best regards
tomasz