Henning,  I  suspected as much, however I think that this has less to do with the seas module and more to do with just an external module returning.  My guess is that somehow execution is returning (0) to whatever is executing the route block and then the config script exits.  I’ve been adding debug to the source for the last two days and I just don’t see where it’s terminating.

 

The receive_msg function (core receive.c) returns 0 after processing the sip request.  The udp_rcv_loop (core udp_server.c) then looks like it should drop through to the error label and return -1.  I don’t see where it goes from here and suspect that it was a spawned thread of execution.

 

 

Hello Daniel,

 

the seas module is unfortunately not much used nowadays, at least according to the (lack of) discussions on this list. You probably need to dig into the code and investigate by yourself to some extent. Maybe your requirements can be fulfilled by another, more commonly used module?

 

Cheers,

 

Henning

 

 

 

I am having some difficulties with the seas module under Kam 5.5.2.  If my application server is not connected then the config file script below never returns

 

if (!as_relay_t (“myserver”)) {

    Xlog (“LM_NOTICE”,  “myserver not connected\n”);

}

 

A diagnostic in the “seas.c” file does report that the app server is not connected, but the one above is never printed.  Any help here would be appreciated.

This email is intended only for the use of the party to which it is addressed and may contain information that is privileged, confidential, or protected by law. If you are not the intended recipient you are hereby notified that any dissemination, copying or distribution of this email or its contents is strictly prohibited. If you have received this message in error, please notify us immediately by replying to the message and deleting it from your computer.