Hi,
 
After some hours around OpenOSP I did it to compile under FreeBSD ;)
 
So.. Next step was to try to find documentation about OpenOSP Server. Problem iscould find much not to say anything.
Everything I found is about the client and about openser and asterisk modules.
 
Can you provide me some sort of configuration for the server?
 
I'm trying to using it with Openser 1.0.0 and my system is running Freebsd 6.0
 
I had a hard time to get it under it as it request some changes in code and also very old stuff, it is possible to have it cooworking with openldad 2.3  and a newer openssl an berkley db?
 
So any information would be usefull as I can't figure out much with documentation avaible I'm more insterested in OpenOSP Server side as I have clear information about client side.
 
Regards,
 
Elton Machado

De: serusers-bounces@iptel.org [mailto:serusers-bounces@iptel.org] Em nome de vmathur@transnexus.com
Enviada: sexta-feira, 12 de Agosto de 2005 16:00
Para: hernan_gomez_1@yahoo.com
Cc: serusers@iptel.org
Assunto: Re: [Serusers] Distributing "OSP enable SER" binary file w/ source code

Hernan,
 
OSP uses Public key based authentication and encrytion schemes, which are stronger than Radius's shared secrets. If you use OSP for authentication and authorization, you need not use Radius. OSP, just like Radius, has a client stack, which is implemented in the SER, and has a Server, which provides centralized call routing, accounting, and security. At the time of startup, the OSP server and the client, the SER in this case, exchange their public keys. The public and private keys can then be used to encode/decode messages as desired.
 
A typical call setup procedure looks like this
1. The source SER goes to the osp server to get the SIP URI corresopnding to the destination. The message is encoded using the source SER's private key.
2. The osp  server decodes the message using source SERs public key and after successful decoding (authentication) returns the route back to the source. Along with the route, it also sends back a digitally signed (using the OSP Servers private key) token.
3. The Source uses the route returned by the OSP Srver to send an INVITE. The INVITE message contains the token issued by the OSP Server
4. The destination decodes/validates the token using the OSP Servers public key. Upon successful validation (authorization) it accepts the call.
 
This saves you the effort  of mantaining cumbersome access lists for authentication. I can provide you with more documentatin on OSP and how to
use SER with OSP if you wish
 
Thanks,
Vikrant
 
-------------------------------------------------------------------------------------------------------------
Fogive my ignorance for I have never heard of OSP before ;) You mentioned Radius in your message. How does Radius authentication work in OSP? I am having a tough time getting mine to work.
 
hernan

vmathur@transnexus.com wrote:
Dear All,
 
I have recently implemented OSP w/ SER. OSP is an ETSI defined protocol, which I am using for ceneralised routing, and security of my inter-domain calls. The problem, however, is that the build process is a little lengthy. I want to contribute my implementation to this group so that anyone who is struggling with SER routing configurations or Radius authentication issues may benefit from it. I was, thus, wondering if we can have a binary file of the OSP enabled SER, that can be distributed with the source code. Does anyone have an opinion on this?
 
Also, for anyone who wants to check-out this implementation, I can provide more details.
 
Thanks,
Vikrant
 
_______________________________________________
Serusers mailing list
Serusers@iptel.org
http://mail.iptel.org/mailman/listinfo/serusers