Hi all,
     
      I installed the SER and Asterisk on two different boxes on LAN.. I  configured the SER and Asterisk in a way thay that the user agents  communicate between them.
Now, the  problem is  in the second  method , if i use the register command in the Asterisk (sip.conf) , the user registers in the SER and we can view that user in the location table in SER,but at the same time the UA's send busy tone and i gets the messege in the asterisk proxy authentication required.
I use this procedure for registeration

1) In the general section of sip.conf
register => user[:secret[:authuser]]@host[:port][/extension]
2)sip.conf
   [mysipprovider-out]
 type=peer
 secret=password
 username=2345
 host=sipserver.mysipprovider.com
 fromuser=2345
 fromdomain=fwd.pulver.com
 nat=yes
 ;context=from-mysipprovider ;
3)In extensions.conf
 exten => _9.,1,Dial(SIP/${EXTEN:1}@mysipprovider-out,30,r)


Can anybody tell me what i am doing wring with this process...
best regards,


Yahoo! Mail goes everywhere you do. Get it on your phone.